Double Post Inground Lift L6800(;A); That Can Be Used

Double Post Inground Lift L6800(;A); That Can Be Used

Double Post Inground Lift L6800(;A); That Can Be Used

¥88

Equipped with extended bridge plate type supporting arm, the length is 4200mm, supports the car tires. Equipped with corner plate, side slide, and secondary

Introduction

The max lifting capacity is 5000kg, suitable for car maintenance, four-wheel alignment.
Equipped with extended bridge plate type supporting arm, the length is 4200mm, supports the car tires.
Each support arm is equipped with a corner plate and a side slide, and a sliding rail is installed on the inner side of the two support arms, and a secondary lifting trolley that can slide along the length of the lift is suspended on it. This kind of design can firstly cooperate with the car's four-wheel positioning. Secondly, the skirt of the vehicle is lifted by the second lifting trolley, so that the wheels are separated from the supporting arm, and the suspension and brake system are repaired.
During non-lifting operation time, the support arm sinks into the ground, and the upper surface is flush with the ground. There is a follow-up bottom plate under the support arm, and the bottom plate is equipped with a maximum limit switch. When the device is raised, the follow-up bottom plate rises until it stops flush with the ground, and fills in the ground recess left by the rise of the support arm. Groove to ensure the leveling of the ground and the safety of personnel during maintenance operations.
Equipped with mechanical and hydraulic safety devices.
The built-in rigid synchronization system ensures that the lifting movements of the two lifting posts are absolutely synchronized, and there is no leveling between the two posts after the equipment is debugged.
Equipped with the highest limit switch to prevent misoperation from causing the vehicle to rush to the top.

Lifting capacity5000kg
Load sharing

max. 6:4 ior against drive-odirection

Max. Lifting height1750mm
Entire Lifting (Dropping)Time40-60sec
Supply voltageAC380V/50Hz(Accept customization
Power3 Kw
The pressure of the air source0.6-0.8MPa
N.W.2000 kg
Post diameter195mm
Post thickness14mm
Capacity of oil tank12L
Post diameter195mm


Related products